3003/3105 Aluminum Sheet Coil for Side Door Open Van

• Customization: Available
• Surface Treatment: Color Coated/Mill Finish
• Application: Transportation Tools, Side Door Open Van
• Model NO.: 3003/3105
• Certification: ISO9001, JIS, GB, En
• Grade: 3000 Series
• Alloy: Alloy
• Technique: Hot Rolled/Cast Rolled
• Temper: H14/H44
• Transport Package: Export Standard Wooden Case
• Specification: According to Customer Requirement
• Trademark: Chalco Aluminum
• Origin: Henan China
• HS Code: 7606125900
• Production Capacity: 25000mt/Month

Product Description

3003/3105  H14 H44 Aluminum Sheet Coil for Van
There are usually 8 kinds of general van: wing type, side door open, lifting and rear door opening, self unloading vehicle with automatic entry and exit device, and the body can be detached and flat. The frame and beam of the car are generally aluminum alloy profiles, the car body is generally aluminum alloy plate, the skin is 3003 3105 coated or not coated ultra wide aluminum coil.


The alloy used for caravan sheet is commonly in the 3000-series, mainly in the 3003 and 3105 range. Temper is selected to satisfy the roll forming, folding and other fabricating requirements associated with caravan construction, mainly in H44 temper, and thickness normally ranges from 0.8mm upto 1.5mm, normally 1.0mm.
Alloy: 3003 and 3105
Temper: H14,H44
Surface: mill finish, whit wash coating
Thickness normally ranges from 0.8mm upto 1.5mm, normally 1.0mm.
Color: front side normally white wash color with high gloss, back side normally clear lacquer.
Width: from 1000mm up to 2650mm


The dump truck used for transporting bulk, granular, powdery material, its hopper with 5A05 aluminum alloy plate welded, body side plate 9--10mm thick, 12--18mm thick, all the body use 5A05 aluminum alloy plate, can greatly reduce the equipment quality, has obvious advantages in energy saving, emission reduction and performance etc.
5A05 is a Aluminum Alloy most widely used, this alloy has high strength, especially with anti fatigue strength: ductility and high corrosion resistance, no heat treatment to strengthen, in the semi cold hardening plastic plastic is good, low cold hardening, good corrosion resistance, good weldability but, the cutting performance of poor polishing. It is mainly used for high demand plasticity and good weldability, low load parts working in liquid or gas medium, such as fuel tank, gasoline or lubricating oil conduit, all kinds of liquid containers and other small load parts made by deep drawing.

Alloy: 5A05
Temper: H32, H34,H36, H38
Thickness: 9--20mm
Width: 1000mm--3000mm
Length: 2000mm---6000mm
Tension Strength n σb (MPa):≥225

Yield Strength σ0.2 (MPa):≥110

Elongation δ10 (%):≥1
Chemical Composition

Alloy	Si	Fe	Cu	Mn	Mg	Cr	Ni	Zn	Ti	Others		Aluminum
										Each	Total
5A05	0.50	0.50	0.10	0.3-0.6	4.8-5.5	--	--	0.20	--	0.05	0.1	Remainder

Detailed Photos